Beyond the bas cs

9. There’s a choice to make. Instruct your fax to carry out this delayed command in one of the following ways:

Option 1: Perform the command once at a certain time on a certain day of the month (For example, “Do this at 5:05 PM on the 30th.”) To select this option, use the numeric keypad to enter the date and time when the fax should perform the command:

Delayed

Enter Time: 30/17:05

Option 2: Perform the command at a certain time each day you press the key. (For example, “Do this at 5:05 PM today.”)

To select this option, use the numeric keypad to enter 0, 0 (i. e., 00), and then the time when the fax could perform the command:

Delayed

Enter Time: 00/17:05

10. Press ENTER, ENTER.

11. The display now shows the next programmable one-touch key.

If you do not wish to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do wish to enter or change this key’s programming, go back to step 3. If you wish to enter or change another key’s programming, go back to step 2.

Programming batch transmission

Note: To erase a programmable one-touch key, refer to page 2.70.

Note: For this operation to work, two things must be true:

The batch box must exist on your machine. (If necessary, see “Creating or modifying a batch box,” pages 2.24–2.25.)

You must know the batch box’s one-digit number (1–5).

To program a batch transmission into a programmable one-touch key:

1. Change to the Fax mode then press PROGRAM, C, 1, ENTER. The display either shows:

Select Program No. 73:No Number Stored

. . . or indicates a command already is programmed into this key. Note: To program a key into which a command other than batch

transmission has already been programmed, you must first erase the key (see page 2.70). Then, return to these instructions and select that key.

If a batch transmission is already programmed into this key, you can change the batch box number, in step 6. (But you can’t change the key to another kind of command. To do that, you must first erase the key and then program that key as described elsewhere in this section.)

If 73 is the key you want to program, skip to step 4. (However, our examples from here will say “75” rather than “73.”

2. Select the key in which you want to program a command or change a previously stored command — if necessary, turn the fliptab to see it, as described earlier — and then press it. Here, we’ve selected 75.

Select Program No. 75:No Number Stored

3. If you change your mind and wish to select a different programmable one- touch key, go back to step 2 before going on to step 4.

4. Do not enter any characters here (if you do, you can’t program a batch transmission into this key). Instead, only press ENTER and then proceed to step 5.

75:Fax Number

_

Note: Again, do not enter any characters here. If you have already accidentally entered any characters here, press CANCEL as many times as needed to erase all of them before proceeding to step 5.

Note: If this key already holds a batch transmission, skip to step 6.

5. Press COMMUNICATION OPTIONS five times and then press ENTER. The

display shows:

Batch Tx

Enter Box No. _

6. Use the numeric keypad to enter the one-digit number for the batch box you wish to assign to this key. Here, we’ve entered 5:

Batch Tx

Enter Box No. 5_

Note: To change an identifier already entered, press CANCEL to erase it. Then re-enter until the number is just as you want it.

7. Press ENTER.

2.66

Page 111
Image 111
Muratec MFX-1500 manual Programming batch transmission, Press Enter