Getting started
1.16

Plug in and power up

1. Plug one end of the
telephone line cord into
the LINE jack on the
machine’s rear side. Plug
the other end of the cord
into a standard telephone
wall jack, just as you would
plug in a phone.
Note: If you have
purchased an
optional handset,
do not confuse its
curled handset cord with the uncurled telephone line cord.
2. Plug the non-pronged end of the AC power cord into the AC power cord jack
on the left side of the machine.
3. Plug the pronged end of the AC power cord into a 120 VAC electrical outlet
(preferably on a surge suppressor, as mentioned on page 1.9).
Important: Be sure that you do not turn the power on (next step) until
after you have removed the transport screws (see page 1.10).
4. Use the AC power switch to turn on your machine. The markings are
international standards: I means on, O means off .
It will take a few seconds for the machine to warm up. The display will show:
** Please Wait **
When the machine is ready to use (standby mode), you will see either . . .
Fax Ready
Apr 14 1998 15:30 . . . or . . .
Copy Ready Num: 1
C1:LTR 100%
Fax mode Copy mode
If the machine beeps, its ALARM light glows and the display shows an error
message, this means there is a problem of some sort. P l eas e co nsult “Just in case...,”
beginning on page 3.1.

Turn off the transport mode

Important: Be sure you do not turn the power on until after you remove the
transport screws. (See “Removing the transport screws,” page 1.10.)
To turn off the transpor t mod e:
1. Power up the machine.
If the machine is already in Fax mode, skip to step 3.
If the machine is in Copy mode, proceed to step 2.
2. Press COPY/FAX to switch the machine to Fax mode.
3. Press PROGRAM, *, E.
Mirror Locked :On
Program/Enter
4. Select Off by pressing PROGRAM. Then press ENTER to turn off the
transport mode. The mirror carriage will mov e to the h o me po s itio n .
Mirror Locked :Off
Program/Enter
Important: If you must reship the machine to any other location, turn on this
mode to move the mirror carriage to the transport po sition (in step 4,
above, press PROGRAM to set the transport mode to On), then power
off and mount the mirror carriage using the four transport screws.