Beyond the basics

Setting the transmission confirmation stamp

You can set your fax machine so that it will automatically place a small stamp mark on the front of each original document that it successfully scans.

Note: This feature is available only for document through the document feeder.

Important: Be sure that this feature is turned off if you are sending original documents you don’t want the fax to stamp.

1. If the machine is in Fax mode, proceed to step 2.

If it is in Copy mode, press COPY/FAX to change to Fax mode.

2. Press PROGRAM, J, 1, 5, ENTER. The display shows your fax’s current stamp setting:

Stamp: Off

Program/Enter

If the setting you see is acceptable, skip to step 4.

Otherwise, proceed to step 3.

3. To change the setting, press PROGRAM once or twice until your chosen setting appears. In this example, we’ve chosen On.

Stamp: On

Program/Enter

4. Press ENTER to save the setting.

Setting the language

While English is the language in which your machine initially is set to display messages and print reports, you can set it to “speak” French or Spanish, too! As you give the order for the machine to change languages, it “rolls” from English to French to Spanish and then back to English.

To make the change from one language to the next, change to the Fax mode then press

PROGRAM, #.

¿Qué es? — or,What is it?

If, after making a language change, you’re not sure which language is showing, press PROGRAM (do not press ENTER), and decide based on what results on the display:

A Num. Une-Touche

is French.

Program./Val.

 

 

 

 

 

A Núm. Una-Tecla

is Spanish.

Program./Sel.

 

 

 

If the language you see is the one you want, press STOP to return to standby mode. If you want to change the language, press STOP to return to standby mode and then press PROGRAM, # again to go to the next language in the cycle.

2.6

Page 51
Image 51
Muratec MFX-1500 Setting the transmission confirmation stamp, Setting the language, ¿Qué es? or,What is it?, Is French