Muratec MFX-1500 manual Programmable one-touch fax dialing

Beyond the bas cs

9. Press ENTER. The display will show:

Enter Password

_

Note: If you know that this sub-address does not have a password, skip to step 11.

10. Use the numeric keypad to enter the appropriate ITU-Tpassword for the box (if there is one; if there’s not, you may skip to step 11, as explained in the first Note, below). In this example, we’ve entered 654321.

Enter password 654321_

Note: If you make a mistake, press CANCEL to back up, then enter the correct number.

When the entry is complete, press ENTER.

11. If you want the transmission to begin immediately every time you press the key, press ENTER again and skip to step 14.

If you want to delay the transmission (perhaps to take advantage of lower

phone rates), press COMMUNICATION OPTIONS, ENTER.

12. There’s a choice to make. Instruct your fax to carry out this delayed command in one of the following ways:

Option 1: Perform the command once at a certain time on a certain day of the month (For example, “Do this at 5:05 PM on the 30th.”) To select this option, use the numeric keypad to enter the date and time when the fax should perform the command:

Delayed

Enter Time: 30/17:05

Option 2: Perform the command at a certain time each day you press the key. (For example, “Do this at 5:05 PM today.”)

To select this option, use the numeric keypad to enter 0, 0 (i. e., 00), and then the time when the fax could perform the command:

Delayed

Enter Time: 00/17:05

13. Press ENTER, ENTER.

14. The display now shows the next programmable one-touch key.

If you do not wish to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do wish to enter or change this key’s programming, go back to step 3. If you wish to enter or change another key’s programming, go back to step 2.

Programmable one-touch fax dialing

To dial a fax call using a programmable one-touch number:

1. If the machine is in Fax mode, proceed to step 2.

If it is in Copy mode, press COPY/FAX to change to Fax mode.

2. Insert the document.

3. Adjust resolution and contrast if necessary.

4. Toggle between transmission from the feeder or from memory if necessary, by pressing MEMORY TRANSMIT.

Note: This toggle affects only a transmission from the ADF. Transmission from the FBS is always memory transmission.

5. Press the programmable one-touch key in which you’ve stored the number. The machine will handle the call from here, performing the operation you’ve programmed either now or later, depending on what you specified. Note: To review the details of each available operation, please review its

appropriate area in these instructions. See page 2.60 for a list of where you may find each operation.

If you programmed this key to delay its operation, the display will show:

** Reserved **

A4Mem95%

However, if you programmed this key to perform the operation immediately after the keypress, the display will show the number:

9-1-972-555-4335

A4Mem95%

2.69