Muratec MFX-1500 manual When using the FBS, When using the Multipurpose tray

SORT COPY

Getting started

When using the FBS

1.	If necessary, press COPY/FAX to change to Copy mode.
	Otherwise, proceed to step 2.	COPY FAX
2.	Open the book cover, place your document face down on the
	FBS and align it with the scale on the right.
	Note: Be sure that you place the original document on the FBS
	in the same orientation as the paper in the paper source (which
	you’ll select in step 4, below).
3.	Gently close the book cover.
4.	Press PAPER SIZE ? to select recording paper (see page 1.31).
5.	Adjust resolution and contrast if necessary.
	Press RESOLUTION to change the resolution.
	Press CONTRAST, then press	or
	to change the contrast.

Note: For copying, your only resolution choices are either superfine or halftone mode.

6. Set the reduction or enlargement rate, if you want. (See “Setting of enlargement or reduction for copying,” page 1.34.)

7. If you want to make only one copy of each page of the document, skip to step 10. Otherwise, proceed to step 8.

8. Use the numeric keypad to enter the desired number of copies for each page in the document. You may choose one to 99 copies. Here, we’ve entered “03” to choose a setting of three copies.

Copy Ready Num: 3 Number of copies

C1:LTR 100%

Note: For fewer than 10 copies, enter a leading zero before the digit — e. g., “03” (although, as shown above, the zero will not appear in the final display.)

9. Pressonce or twice to “Toggle” (switch on or off) the sorting of copies, as desired.

10. Press START to begin the copying process.

Note: To stop the copying before it is through, press STOP.

Note: Thanks to your machine’s QuadAccess feature (see page 2.35 for more), copying doesn’t keep you incommunicado while in progress: you can start a fax or voice call and even receive a voice call during copying.

When using the Multipurpose tray

When you need to use a size of paper not currently loaded in your machine’s paper cassette(s), or when you want to use a special type of paper (such as transparency film), use the Multipurpose tray.

Important: If loading transparency (OHP) film into the multipurpose tray, be sure that the sheet is designed for laser printers and not for copiers. Also, be sure that the film does not have a paper backing and/or a leading strip. If it does, remove the paper backing and/or strip before inserting. Only film should go in, not film with any backing or strip.

1. Either insert the document in the ADF or place it on the FBS.

2. Place a sheet of printout paper on the Multipurpose tray. Then align the paper guides to the sheet’s edges and insert the sheet until it comes to a stop. Note: Place the original

document in the same orientation as the paper in the paper source (which you’ll select in step 5, next page).

•If you are going to make more than one copy, you should insert the printout paper only one page at a time.

•You may use letter-, legal- or half-letter sized paper. (Half-letter is 8.5″ wide × 5.5 ″ tall.)

1.33