Muratec MFX-1500 manual 03Box NameUpper

Beyond the bas cs

5. If you change your mind and wish to select a different F-Code box, just use the numeric keypad to enter the two-digit number for the desired box before going on to step 6.

6. Press ENTER.

If you are creating this F-Code box for the first time, skip to step 8.

If you selected a previously created F-Code box which has a previously set passcode, the display will show:

03:Set F-Code Box F-Code Passcode:****

7. To modify this previously created F-Code box, enter the proper passcode (not the ITU-Tsub-address and not the ITU-Tpassword) using the numeric keypad, then press ENTER.

Note: If you enter an invalid passcode, the fax machine will reject the attempt and abort this operation.

8. The machine now is prompting you for a name for this F-Code box. Depending on whether you already have a name entered for this F-Code box, the display now shows either:

03:Box Name:Upper	or	03:Box Name:Upper
_		03:Muratec America_

To enter or change this F-Code box’s name, proceed to step 9.

If you do not wish to enter or change this F-Code box’s name, skip to step 10.

9. A F-Code box’s name may be up to 16 characters in length. You enter the name the same way you entered your fax name during EasyStart. We’ll review the process, here. (If you’re changing a previously entered name, see the note at the end of this step.)

Important: As in EasyStart, you enter letters and other non-numeric characters through the one-touch keys.

03:Box Name:Upper

_

The word “Upper” means the machine is currently set for entering only upper-case letters. If you press R, the machine will see it as an R (not an r).

To change it so that pressing a one-touch key will produce a lower-case letter rather than an upper-case letter, press ALPHABET. The display will change to:

03:Box Name:Lower

_

This means pressing one-touch keys will enter lower case letters: pressing R, will produce an r (not an R) on the display.

To switch back for upper-case entries, press ALPHABET again.

To use CODE to enter a wide variety of characters, please review the explanation on page 2.3. The vast majority of the time, you will probably find the ALPHABET keys to be sufficient.

Note: If you make a mistake or want to erase characters entered in a previous setting, press CANCEL to erase leftward. Or, if you want

to change just one character in the name, press to move the

cursor leftward, or to move it rightward, to that character and press CANCEL to erase it. Then re-enter until the name is just as you want it.

10. Press ENTER to save the box’s name and continue. The display shows either:

03:Sub-Address No.	or	03:Sub-Address No.
_		123456_

The machine is asking for this F-Code box’s sub-address. This ITU-T- standard, all-numerical identifier is essential for F-Code communication. You must enter one to use this F-Code box, and anyone trying to fax to this F-Code box must know it.

To enter or change the sub-address number, proceed to step 11.

If you do not wish to change an existing sub-address number, skip to step 12.

2.50