Muratec MFX-1500 manual Code transmission and polling, We’ve entered, Press Enter

Beyond the bas cs

6	Use the numeric keypad to enter your F-Code’s four-digit passcode. Here
	we’ve entered 2345:
		03:Print F-Code Doc.
		F-Code Passcode:2345
7
	Press ENTER.

∙ If you’ve entered the correct passcode, your fax machine will print all documents in — and then erase them from — the mailbox.

∙ If you’ve entered an incorrect passcode, your fax machine will refuse to print the document.

F-Code transmission and polling

With F-Code, your machine — in addition to sending Muratec-proprietary SecureMail (pages 2.38–2.41) and performing database polling (pages 2.31–2.32) from only other Muratec models — can send secure transmissions to, and perform database polling from, other makers’ machines, as well. You may accomplish such transmissions in either of two ways:

∙Programmable one-touch key (see pages 2.67–2.69)

∙Direct entry of the ITU-Tsubaddress and password, which is what we will now describe.

Whether you are sending to or polling from another machine, you obviously must know the correct sub-address on the receiving machine, as well as the password if that sub-address has one. (This is analogous to how, with Muratec SecureMail, you must know the correct SecureMail mailbox number and password on the remote Muratec fax.)

Note: For F-Code communication to occur, three things must be true:

∙The remote fax machine must support ITU-Tsub-addressing (and password) capabilities.

∙A mailbox with an ITU-Tsub-address must exist on the remote fax. (It doesn’t have to have a password. If the other machine hasn’t at least one box with a sub-address, F-Code communication will be impossible.)

∙You must know the ITU-Tsub-address and (if applicable) password information for the mailbox on the remote machine.

F-Code transmission

1. Press COPY/FAX to change to Fax mode, if necessary.

2. Insert the document.

3. Adjust resolution and contrast if necessary.

4. If you wish to toggle between transmission from the feeder and transmission from memory, press MEMORY TRANSMIT.

Note: This toggle affects only a transmission from the ADF. Transmission from the FBS is always memory transmission.

5. Press COMMUNICATION OPTIONS seven times and then press ENTER.

7.F-Code TX

Comm.Option/Enter

6. Press ENTER.

Enter Sub-Address

_

7. Use the numeric keypad to enter the appropriate sub-address number. In this example, we’ve entered 123456.

Enter Sub-Address 123456_

Note: If you make a mistake, press CANCEL to back up, then enter the correct one-digit number.

8. Press ENTER. The display will show:

Enter Password

_

Note: If you know that this sub-address does not have a password, skip to step 10.

9. Use the numeric keypad to enter the appropriate password number. In this example, we’ve entered 654321.

Enter Password 654321_

Note: If you make a mistake, press CANCEL to back up, then enter the correct one-digit number.

10. Press ENTER. The display will show:

Enter Fax Number

_

11. Enter the fax number either by pressing a one-touch key, entering a speed- dial number or dialing from the numeric keypad. Do not press START.

12. What you do now depends upon when you wish the transmission to begin. ∙ To have it begin now, skip to step 15.

∙ To delay it, proceed to step 13.

2.58