Muratec MFX-1500 manual Setting scanner width, Press

Beyond the basics

Setting scanner width

Your fax accepts original documents up to 8.5″ wide. The factory setting causes your fax to scan the middle 8.2″ of each 8.5″ page. However, if you wish, you can increase the scanning width to the full 8.5″.

Note: When your fax machine is set to scan the full width, certain documents will require longer transmission times.

Important: When you make this setting, you must turn your fax completely off and then back on again before it will take effect. If this will interfere with any delayed operations currently set on your fax, do not make this setting until your fax has completed all of these delayed operations.

To change your fax’s current scanner width setting to its maximum:

1. Change to the Fax mode then press PROGRAM, *, 1.

Set Memory Switch

Program/Enter

2. Press ENTER.

A0: 00000110

Program/Enter

3. Press E.

E0: 00000101

Program/Enter

4. Press ENTER.

Set Memory Switch

E0 00000101

5. Press or repeatedly until the cursor is under the next-to-rightmostcharacter, as shown.

Set Memory Switch

E0 00000101

6. Press 1.

Set Memory Switch

E0 00000111

7. To abort the change, skip to step 8. To save the change, press ENTER.

8. Press STOP to return to standby.

Note: To return to the regular setting, repeat this procedure but press 0 (rather than 1) in step 6.

2.72