
Installing and Operating AN/DC and
Installing the AN/DC
With all cabling attached, you can install the AN/DC in any of the following ways:
•Position the AN/DC on a flat, sturdy surface.
•Install the AN/DC in an electronic enclosure rack.
•Mount the AN/DC on a wall.
The following sections provide instructions for each option. Refer to the appropriate section when positioning your AN/DC.
Positioning the AN/DC on a Flat Surface
To position the AN/DC on a flat surface:
1.Make sure that the surface is large enough for the AN/DC to operate properly.
The surface must be sturdy enough to support the combined weight of the AN/DC and any cables you connect.
2.Peel the paper backing off the four rubber feet supplied with the AN/DC and attach them to the embossed feet on the bottom of the AN/DC.
3.Set the AN/DC in the chosen location.
You can now connect the network cables to the AN/DC. Go to the section
“Connecting Communications Cables,” later in this chapter.
Installing the AN/DC in a Rack
For this procedure, you need
•Mounting hardware that came with the AN/DC shipment
•An electronic enclosure rack
•Phillips screwdriver
Note: If the rack’s rail does not have threaded holes, you must supply and attach four cagenuts.