Installing and Operating AN/DC and
Booting Access Node...
Starting OS kernel for network boot...
Attempting Directed Netboot.
Directed Netboot using active IP interface XCVR1. Retrieving config 'config' from network. done Retrieving image 'krnl_an.exe' from network......done
Nortel Networks, Inc. and its Licensors.
Copyright 1992, 1993, 1994, 1995, 1996, 1997, 1998. All rights reserved.
Login:
AN0070A
Figure 3-11. Directed Netboot
Note: If the router cannot find a software image or configuration file via Directed Netboot, it attempts to Local Boot once. If both attempts fail, the AN Diagnostic Monitor Login prompt (AN_DIAG>) appears on the console. In this case, you or your network administrator must troubleshoot the problem.
After the router reboots, it gets a configuration file from a TFTP server and loads the software image from the local file system.
The router starts bridging and routing traffic.
7.When you boot the router, its LEDs flash in a particular order. To interpret the LED sequence and troubleshoot any potential problems, refer to Chapter 4.
After connecting the router to the network, you can replace the console connection with a modem connection to enable remote
