Nortel Networks AN/DC manual Table A-3 Bconfig Command Options

				Configuring Netboot and Directed Netboot
Table A-3.	The bconfig Command Options
Option		Description
image		Specifies information about the software image.
config		Specifies information about the configuration file.
local		Indicates that the specified file (image or config) resides in the router’s local file
		system.
network		Indicates that the specified file resides on a network server.
<tftp_host>		Specifies the IP address of the host where the image or configuration file resides.
		If both the software image and configuration file reside on the network, the files must
		reside on the same host. In other words, you must specify the same IP address for
		the tftp_host for both files.
<tftp_pathname>		Specifies the complete pathname of the software image or configuration file on the
		host.
-d		Resets the default values for the software image or configuration file.
		The command bconfig -d image tells the router to look for the image file locally and
		nullifies the IP address and pathname for the file.
		The command bconfig -d config tells the router to obtain the configuration file over
		the network and nullifies the IP address and pathname for the file.
		Without the IP address and pathnames, the router uses Netboot rather than Directed
		Netboot. However, if you want to get one file locally while using Directed Netboot for
		the other file, you can use the bconfig command as the following examples show:
		bconfig	image	local
		bconfig	config	network 21.3.5.62 /usr/anstartup/config
		Or,
		bconfig	image	network 21.3.5.62 /usr/mykernel.exe
		bconfig	config	local

312410-A Rev 00 A-5