Nortel Networks AN/DC manual Connecting a Second Ethernet Interface UTP Cable

Installing the ANH-8/DC

Connecting a Second Ethernet Interface UTP Cable

Complete these steps to connect a UTP cable to the back panel UTP-2 port.

Note: This section does not apply unless you have upgraded the ANH-8/DC with a Second Ethernet Interface module.

1.Attach a UTP cable to the back-panel RJ-45 connector (Figure 2-12).

-48VDC	COM 3/Expansion	COM 2	COM 1
-60VDC
1.5A

RTN -VDC

TX

RX

UTP-2 COL

Second Ethernet

UTP Cable Connector

AN0047B

Figure 2-12. Connecting a Second Ethernet Interface Cable

2.Connect the other end of each cable to the communications device.

312410-A Rev 00 2-17