Nortel Networks AN/DC manual Verifying the Interface Configuration, Reset

Installing and Operating AN/DC and ANH-8/DC Systems

	AN_DIAG>> getcfg
	Boot Options:
			boot image=local
			boot config=network
Verify	NetBoot Parameters:
			XCVR1...IP=192.32.37.125, Mask=255.255.255.224
			COM1....EZ-Install
			COM2....EZ-Install
			XCVR2...None
	AN_DIAG>>
			AN0065A
Figure 3-7.		Verifying the Interface Configuration
		Note: The location of the image and configuration file is either local or
		network. Local means that the an.exe or config file is stored on the router’s
		local file system (Flash memory card). Network means that the an.exe or
		config file is stored on a workstation located across the network.

5.If the configuration information is correct, continue to the next step. Otherwise, reenter the correct ifconfig command. Contact your network administrator if you need assistance.

6.Type the following command and press the Return key to run the diagnostic tests to completion and boot the AN:

reset

Or type boot and press the Return key to boot the router without running the diagnostic tests.

Figure 3-8 shows sample output from a boot command.

3-10 312410-A Rev 00