Nortel Networks manual Mounting the AN/DC on a Wall

Installing the AN/DC

Mounting the AN/DC on a Wall

When mounting the AN/DC on a wall, keep the following in mind:

•Make sure that the wall is at least 3/8 in. (0.96 cm) thick, and is made of Sheetrock or wood.

•You need the following equipment before you start:

--An electric drill

--A Phillips screwdriver

--Two wall-mount anchors

To mount the AN/DC on the wall:

1.Drill two 5/16-in. (0.8 cm) holes in the wall 5-1/4 in. (13.34 cm) apart, at least 3 ft. (0.915 m) off the floor.

2.Insert one wall-mount anchor into each hole.

3.Tighten the anchors with a Phillips screwdriver.

4.Back the head of each screw out 1/8 in. (0.32 cm) from the wall.

5.Hang the AN/DC on the wall by aligning the keyhole cutouts on the back of the AN/DC with the protruding screw heads (Figure 1-5).

312410-A Rev 00 1-9