Nortel Networks AN/DC manual Running the Quick-Start Script

Using Local Boot (the Quick-Start Procedure)

Running the Quick-Start Script

After you enter run install.bat, the AN/DC or ANH-8/DC progresses through the Quick-Start script as follows:

1.The script begins prompting you for the initial Global Worksheet information.

2.After you select a router protocol option, the script prompts for specific protocol information.

3.After finishing the router protocol configuration, the script requests a wide area protocol selection.

4.After you select a wide area protocol, the script prompts for specific protocol information.

5.After finishing the wide area protocol configuration, the script prompts for the rest of the Global Worksheet information.

When the configuration is complete, the router runs through a test procedure for the IP interface. When the test is complete, the following prompt appears:

Enter IP address of Site Manager workstation:

Obtain this information from your network administrator.

312410-A Rev 00 B-13