Starting the AN/DC and
5 | 6 | 7 | 8 |
|
| Partition |
|
|
| |
|
|
|
|
|
|
|
|
| ||
|
|
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
|
|
|
|
|
| Link |
|
|
|
AN0061A
Figure 3-3. Inserting a Flash Memory Card in the ANH-8/DC Card
Receptacle
Using EZ Install
To use the EZ Install feature:
1.Install the router and attached communications equipment as described in Chapter 1 (AN/DC) or Chapter 2
There must be at least one synchronous connection to one of the COM ports.
Although you do not need a modem or console connection for EZ Install, we strongly recommend that you connect a modem or console. This lets you issue commands to the router and view messages.
2.Contact your network administrator to verify that the remote network is set up so that you can start the EZ Install procedure.
3.Be sure that the Flash memory card is installed, as described earlier in this chapter.
4.Supply power as described in this chapter.
As the router powers on, it begins diagnostic tests. Your console displays the message *****Testing Memory***** with the amount of memory available.
Once it passes diagnostic tests, the router automatically activates and completes EZ Install. (It gets a software image from the local file system, its IP address from the upstream router, and a configuration file from the BootP server.) The router then starts bridging and routing traffic.
When booting, the AN/DC and
