Nortel Networks AN/DC manual Power Source

Installing the AN/DC

Once you have the appropriate equipment, complete the following steps:

1.Insert the 9-pin receptacle end of the console cable into the CONSOLE port on the AN/DC back panel (Figure 1-9).

2.Attach the null modem crossover adapter to the other end of the console cable (refer to Figure 1-7).

3.Attach the 25-pin receptacle end of the cable-plus-adapter to the PC console cable’s 25-pin plug connector.

4.Connect the complete cable unit to the communications port at the back of the PC (Figure 1-9).

UL

UL

-48VDC

-60VDC

1.5A

XCVR	UTP	TX	CONSOLE	COM 2	COM 1
		RX	RST
		CL	RSLD2	RSLD1
					RTN	-VDC

PC Cable

Null Modem Adapter

Console Cable

AN0012A

Figure 1-9. Connecting a PC Console

The PC console is now connected. Proceed to the section “ Connecting to the DC

Power Source.”

312410-A Rev 00 1-15