•Check the batteries. If they are low or exhausted, the transmission range may be shortened.
•Force a signal search (see “Signal Search” section).
2.The gym equipment does not seem to work with your chest belt and the digital icon 
is displayed:
•Most gym equipment is compatible with the analog system 
. Press and hold the chest belt button for more than 4 seconds to change from digital to analog. Then force a signal search (see “Signal Search” section).
3.Interference from another person’s heart rate monitor - their heart rate readings appear on your watch, or the heart rate monitor shows “0”:
•Press the chest belt button to get the watch to receive your chest belt signal. Do not press and hold the chest belt button, as it will change the transmission signal from digital to analog.
4.The signal is jammed - the heart rate reading on your watch is flashing:
•There is too much interference in the environment for your heart rate monitor to function. Move to an area where the heart rate reading stops flashing.
WARNING Signal interference in the environment can be caused by electromagnetic disturbances. These may occur near high voltage power lines, traffic lights, overhead lines of electric railways, electric bus lines or trams, televisions, car motors, bike computers, some motor driven exercise equipment, cellular phones or when you walk through electric security gates. Under interference, the heart rate reading may become unstable and inaccurate.
SIGNAL SEARCH
To force a signal search:
1.Press MODE to navigate to the SMART TRAINING PROGRAM or Stopwatch Mode.
2.Press and hold MODE for 2 seconds. The signal- searching icon with the outside flashing will appear to confirm a signal search is taking place. Whenever the watch is searching for the chest belt signal make sure that the chest belt is no further than 10 cm (4 inches) from the watch.
The signal search will take approximately 10 seconds. If after 10 seconds the heart icon is not flashing, then your signal search has been unsuccessful and you need to force another signal search.
See the table in the “Transmission Signal” section for more signal status information.
ABOUT THE SMART TRAINING PROGRAM
The SMART TRAINING PROGRAM enables you to complete exercise cycles effectively. It will guide you through from a
EN
15
