Transmission Features

Transmission Features

Stamp

The optional Document Feeder is re- quired.

Note

When the stamp starts getting lighter, replace the cartridge. See P.91 “Replacing the Stamp Car- tridge”.

When sending a fax message using the Document Feeder (ADF), the ma- chine can stamp a circle mark at the bottom of the original. This stamp in- dicates that the original has been suc- cessfully stored in memory for Memory Transmission, or that it has been successfully sent for Immediate Transmission.

Limitation

Stamp only works when scanning from the Document Feeder.

You cannot turn the Stamp feature on or off while a document is being scanned.

Do not open the Document Feeder while scanning the document. Document jam could occur.

If a page was not stamped even though the Stamp feature is turned

on, you need to re-send that page.

3

By default, Stamp is turned off. If you use this feature often, you can adjust the User Parameters so that the home setting is on. In this case, Stamp can easily be turned off for

any single transmission by press- ing the {F3} key. See P.72 “User Pa- rameters” (Switch00, Bit0).

A Press the {F3} key.

The Stamp indicator will light. Pressing the {F3} key again will turn it off.

27

Page 110
Image 110
Savin 1018 manual Transmission Features, Stamp, Press the F3 key