Key Operator Settings

Line Type

You must register the Line Type before you connect the machine to the line.

Note

By default, Line Type is set to “Tone”.

This function is not available in some areas.

If you do not know the type of line you are connected to, select "Tone" and dial a trial number. If the con- nection was successful, your Line Type is "Tone", if it did not, set the Line Type to "Pulse" and dial a trial number. If the connection was suc- cessful, your Line Type is "Pulse".

6

Limitation

If you do not correctly set the Line

Type, you will be able to receive messages, but you may not be able to send them.

To register the Line Type, perform the following procedure.

Note

You can edit the registered Line Type by performing the steps for registering the Line Type in the fol- lowing procedure.

A Press the {User Tools} key.

B Press 0 or 1 until "4. Fax Fea- tures" is displayed.

CPress the {OK} key.

D Press 0 or 1 until "6. Key Op. Tools" is displayed.

EPress the {OK} key.

Note

If the key operator code is regis- tered and turned on, enter the

key operator code and press the {OK} key.

F Press 0 or 1 until "7. Line Type" is displayed.

GPress the {OK} key.

H Press 0or 1and select "Tone" or "Pulse".

IPress the {OK} key.

"Function Accepted" is displayed on the screen.

J Press the {Cancel} key on each display until you reach the stand- by display.

82

Page 165
Image 165
Savin 1018 manual Line Type, If you do not correctly set the Line