Transmission Options

14

1
CPress 0
00
0 or 1
11
1 until "10. Transfer
Report" is displayed.
DPress the {
{{
{OK}
}}
} key.
EPress 0
00
0 or 1
11
1 to select "On" or
"Off".
FPress the {
{{
{OK}
}}
} key.
GSpecify the Transfer Station.
If you make a mistake, press the
{Clear/Stop} key and try again.
HPress the {
{{
{OK}
}}
} key.
ISpecify the End Receiver.
Note
You cannot enter the numbers
of the End Receivers directly.
The numbers must be stored in
Quick Dials, Speed Dials or
Groups in the Transfer Sta-
tion(s).
JPress the {
{{
{OK}
}}
} key.
KPress 0
00
0 or 1
11
1 to select "Yes" or
"No".
LPress the {
{{
{OK}
}}
} key.
If you selected "Yes", go back to
step I.
MPress the {
{{
{Start}
}}
} key.

Specifying an End Receiver

When you make a Transfer Request,
you must specify the fin al destina-
tions (End Receivers) for your mes-
sage.
You cannot enter the numbers of the
End Receivers directly. Instead, enter
a simple code that describes where
the numbers are stored in the Trans-
fer Station (in Quick Dials, Speed Di-
als or Groups).
The numbers must first have been
stored in Quick Dials, Speed Dials or
Groups in the Transfer Station(s).

Quick Dial

Enter {q} followed by the
number (2 digits) of the Quick Dial
where the End Receiver is stored.
For example, to choose the number
stored in Quick Dial 01 in the
Transfer Station, enter: {q} {0}
{1}

Speed Dial

Enter {q}, {p} followed by the
Speed Dial code (2 digits).
For example, to choose the number
stored in Speed Dial 12 in the
Transfer Station, enter: {q} {p}
{1} {2}

Group Dial

Enter {q} , {p}, {p} followed
by the Group number (2 digits).
For example, to choose the number
stored in Group 04 in the Transfer
Station, enter: {q} {p} {p} {0}
{4}