Sharp SF-1120, SF-1020 service manual Memory simulation list

5. Memory simulation list

							Contents
Purpose/kind	Section	Main	Sub	Default					Description	Ref. page
		code	code	value
	Paper feed	51	02	50	Adjustment value of contact pressure of the paper on the main					8-19
	section				body resist roller
		50	01		Copy paper lead edge void amount adjustment					8-18
					(Resist adjustment A)
					Copy paper lead edge void amount adjustment
					(Resist adjustment B)
					Copy paper lead edge void amount adjustment
					(Lead edge void adjustment )
					Copy paper lead edge void amount adjustment
					(Rear edge void adjustment)
		46	01		Adjustment value of copy density (exposure level) in each copy					8-17
					mode and of copy density gradient (exposure gradient)
					Manual copy mode density level 1 (Not toner save mode)
Adjustment	Optical unit				Manual copy mode density level 5 (Not toner save mode)
					Manual copy mode density level 1 (Toner save mode)
					Manual copy mode density level 5 (Toner save mode)
					Auto copy mode density level 1 (Not toner save mode)
					Auto copy mode density level 5 (Not toner save mode)
					Auto copy mode density level 1 (Toner save mode)
					Auto copy mode density level 5 (Toner save mode)
					Photo copy mode density level 1 (Not toner save mode)
					Photo copy mode density level 5 (Not toner save mode)
		47			The AE sensor and the optical section characteristics memory data					8-17
					for the change in the copy lamp application voltage
		48	01	50	The vertical copy magnification ratio adjustment value					8-17
			02	50	The horizontal copy magnification ratio adjustment value (when the					8-18
					document table is used)
	Developer unit	25	02		Toner density initial set value					8-9
Setting	Specifications	26	06		Specifications setting by destination					8-10
						Code No.			Destination
						0		Japan
						1		U.S.A.
						2		Canada
						3		Europe except U.K.
						4		U.K.
						5		Australia
						6		Inch series outside Japan
						7		AB series outside Japan
	Fuser unit	26	13	0	Setting of the main motor operation mode in warming up.					8-10
						Code	Operation		Operation
						No.	mode
						0	Normal		When the fusing temperature reaches
							mode		the specified level, the main motor stops.
						1	Long		The main motor keeps rotating until the
							mode		completion of the warming up.
		43	01	185°C	Fusing temperature set value					8-13
	Maintenance	21	01		Maintenance cycle setting					8-8
	counter		02		Mini maintenance cycle setting					8-8
	Developer unit	22	06		Used to confirm the developer counter value of the installed					8-8
					developer unit.
			07		Used to confirm the developer replacement cycle of the installed					8-8
					developer unit.

10 – 4