9. Center shift adjustment
There is basically no need to perform the center shift adjustment because it is made when shipping. If the center should be shifted, adjust in the following procedures.
Make a copy. If the center is shifted as shown in Fig. 1 or Fig. 2, loosen the four screws which are fixing the cassette grip cabinet.
Section b |
| Section b | |||||
Section a | Direction A | ||||||
Section a | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Direction B
(Note) When fixing the cassette cabinet, the fixing screws and the cabinet clearance a and b are in symmetry.
[Reference figure]
Section b
Section a
(1) Fig. 1
Move the cassette grip cabinet in direction A, tighten two fixing screws (a) and tow fixing screws (b) in this sequence. Make a copy again and check the center.
[Fig.1] |
| Paper center line |
|
|
|
Image center line (First image)
(2) Fig. 2
Move the cassette grip cabinet in direction B, tighten two fixing screws (a) and tow fixing screws (b) in this sequence. Make a copy again and check the center.
[Fig.2] |
| Paper center line |
|
|
|
Image center line (First image)
10. Label attachment
A. Label attachment
Attach the magnification ratio select label packed together with the Operation manual to the position shown in the figure below.
•When attaching the label to the copier with the original cover.
Magnification ratio select lable
•When attaching the label to the optional automatic original feeder
Magnification ratio select lable
4 – 7
