Sharp SF-1020, SF-1120 service manual Me + Pe, Ae + Pe

Main code	Sub code					Content
46	01	Exposure level adjustment
		Used to set the copy density (copy lamp output voltage) in each exposure mode.
		When this simulation is executed, warm-up is started and the currently set manual (ME) upper limit value is
		displayed on the copy quantity display.
		When warm-up is completed, the ready lamp lights up. When the PRINT button is pressed, copying is performed
		in the currently set exposure mode.
		Since there are two or more display items, the third digit is used to make distinction between the light reception
		level and the original judgment level, and the lower two digits are used to display the data.
		The display is selected by the magnification ratio key, the exposure key, or the density select key.
			Copy quantity display		Exposure section		Display data
					display
			3rd digit	2nd, 1st digits
			A	1 ∼ 99	ME	exp. 1	Manual (ME) upper limit value
			b		ME	exp. 5	Manual (ME) lower limit value
			C		ME + PE	exp. 1	Manual (ME) toner save upper limit value
			d		ME + PE	exp. 5	Manual (ME) toner save lower limit value
			E		PE	exp. 1	Photo (PE) upper limit value
			F		PE	exp. 5	Photo (PE) lower limit value
			G		AE	exp. 1	Auto (AE) slant
			H		AE	exp. 5	Auto (AE) lower limit value
			I		AE + PE	exp. 1	Auto (AE) toner save slant
			J		AE + PE	exp. 5	Auto (AE) toner save lower limit
		The setting range is 1 ∼ 99. The greater the set value is, the brighter the copy density is.
		After completion of setting, press the CA key to cancel the adjustment mode.
		(Note) Auto (AE) slant and auto (AE) toner save slant must be set to 0.
47	—	AE sensor characteristics measurement
		Used to read the E sensor input value when the copy lamp is lighted at the specified voltage and to set the AE
		sensor gain.
		When this simulation is executed, the mirror base is initialized and fed to the measurement position. After
		completion of feeding, the previously measured AE sensor input value is displayed on the copy quantity display
		and the ready lamp is lighted.
		Press the PRINT button, and the copy lamp is lighted at the specified voltage interval. The AE sensor input value
		at that time is read and stored. After completion of reading, the copy lamp is turned off and the measured AE
		sensor is displayed on the copy quantity display.
		At that time, the AE sensor gain is automatically adjusted.
		(Note) Place 4 or 5 white sheets on the table glass during execution of this simulation.
48	01	Front/rear direction magnification ratio adjustment
		Used to set the vertical (front/rear direction) copy magnification ratio.
		When this simulation is executed, warm-up is started and the currently set normal correction value is displayed on
		the copy quantity display.
		Since there are two or more display items, the third digit is used to make distinction between the light reception
		level and the original judgment level, and the lower two digits are used to display the data.
		The display is selected by the magnification ratio key.
			Copy quantity display			Display data
			3rd digit	2nd, 1st digits
			A	1 ∼ 99	Normal correction value
			b		Zooming correction value (reduction)
			C		Zooming correction value (enlargement)
		The setting range is:
		normal correction range; 1 ∼ 99 (initial value: 50)
		zooming correction value; 10 ∼ 90 (initial value: 50)
		After completion of setting, press the CA key to cancel the adjustment mode.

8 – 17