Sharp SF-1120, SF-1020 service manual Paper feed unit SF-CM15, SF-CM16, option

<Reverse roller>

1Remove three fixing screws (M4 × 10) of the left cabinet, and remove the left cabinet. Remove the plastic E-ring which is fixing the paper exit cabinet unit, and slide the paper exit cabinet unit in the arrow direction and remove it from the copier.

2Remove two fixing screws (M4, flat) of the paper exit cabinet unit and one fixing screw (M3 × 6) of the paper exit plate spring.

3Remove two E-rings (7E) at the both ends of the reverse roller.

4Remove the gear and the parallel pin (???3 × 10) from the reverse roller.

5Remove two E-rings (E7) inside of the gear.

6Remove two bearings at the both ends of the reverse roller.

7Slide the reverse roller in the direction of Q.

12.Paper feed unit (SF-CM15, SF-CM16, option)

This unit had two stages of paper feed section of the SF-2020 (one stage for the SF-CM16). For disassembly and assembly, refer to [5]-(1) Paper feed section.

6 – 27