![](/images/new-backgrounds/1125774/125774189x1.webp)
Main code Sub code | Content |
0210 ADF individual load operation check (paper feed motor + paper feed solenoid)
11 ADF individual load operation check (transport motor forward rotation + repulsion motor forward rotation) A57 only
03 | 02 | Sorer sensor state display |
|
| |
|
| The ADF sensor ON/OFF states can be monitored with the LED on the operation panel. | |||
|
| When the third digit of the multi display is “A,” the following display is made. |
| ||
|
|
|
|
|
|
|
|
| Sensor name | Operation panel LED |
|
|
|
|
|
|
|
|
|
| Entrance sensor | Jam lamp (ê) |
|
|
|
|
|
|
|
|
|
| Tray paper presence/empty sensor | Paper empty sensor (ç) |
|
|
|
|
|
|
|
|
|
| Upper limit sensor | Manual feed selection lamp |
|
|
|
|
|
|
|
|
|
| Lower limit sensor | Resist position jam lamp (▼) |
|
|
|
|
|
|
|
|
|
| Bin home position sensor | Drum position jam lamp (▼) |
|
|
|
|
|
|
|
|
|
| Paper exit jam lamp (▼) |
| |
|
|
|
|
|
|
|
|
| Alignment bar home sensor | ADF section jam lamp (▼) | S54 only |
|
|
|
|
|
|
If, at that time, the magnification ratio display key is pressed, the third digit of the multi display is changed to “B” and the following display is made.
|
| Sensor name | Operation panel LED |
|
|
|
|
|
|
|
|
|
| Pinch (hold) home sensor | Jam lamp (ê) | S54 only |
|
|
|
|
|
|
|
|
| Stapler home sensor | Paper exit position jam lamp (▼) | S54 only |
|
|
|
|
|
|
|
|
| Stapler paper sensor | Paper empty jam lamp (ç) | S54 only |
|
|
|
|
|
|
|
|
| Stapler near end sensor | Resist position jam lamp (▼) | S54 only |
|
|
|
|
|
|
|
|
|
|
| ||
03 | Sorter individual load operation check (Transport motor) |
|
|
04Sorter individual load operation check (Bin motor)
05Sorter individual load operation check (Buzzer)
06Sorter individual load operation check (Alignment motor)
07Sorter individual load operation check (Pinch hold motor)
05 | 01 | Operation panel display check |
|
| All the LED's on the operation panel are lighted for 5 sec. |
|
| When the automatic original feed unit is installed, the original feed lamp and the original remaining lamp are also |
|
| lighted for 5 sec. |
|
|
|
| 02 | Heater lamp lighting check |
|
| The heater lamp is turned of/off in the following sequence. |
PR |
|
|
HL |
|
|
0.5s | 0.5s | 0.5s |
03 | Copy lamp lighting check |
The copy lamp is turned on/off in the following sequence.
PR
CL |
|
|
0.5s | 1s | 5s |
Full power ON | Data ON (Can be set by the exposure key arbitrarily |
8 – 5