3. Placing the main copier unit over the paper feed unit
[Note]
•The following procedure should always be performed by two per- sons.
Lift the main copier unit by the grips and slip the two positioning holes on the bottom of the main copier unit over the two position- ing bosses on the paper feed unit, then set the four feet on the main copier unit in their proper places on the paper feed unit.
Grips
Grips
Positioning bosses
Grips
Positioning bosses
4. Removing the lower tray from the main copier unit
While lifting up slightly on the main copier unit's lower tray, pull it out gently as far as it will go.
Then lift up on it a little bit with both hands to remove it from the copier.
5. Attaching the main copier unit and paper feed unit
Orient the protrusions on the securing fixture (one of the included parts) toward yourself as shown in the illustration and attach it with the two mounting screws "A".
Then attach the left side with the mounting screw "B".
Finally, reinsert in the main copier unit the tray that was remove in step 4.
Attach the rear side of the main copier unit to the paper feed unit using the two securing screws "C".
| Securing fixture |
Mounting screw "B" | Mounting screw "A" |
| Mounting screw "C" |
Mounting screw "C"
6. Plugging in the relay harness
Remove the tape holding the connector to the rear cover of the paper feed unit, then plug the 4P and 16P connectors into the correspond- ing connectors on the main copier unit.
4P connector
16P connector
Tape
4P connector
7.Mounting the rear cover to the main copier unit's lower tray
Put the rear cover, which was removed in step 1, back where it came from and secure it with its two securing screws.
Securing screws
Rear cover
Securing screws
4 – 10
