
(11)Make a normal copy and check that the image loss and the void amount are within the specified range.
(Specified range)
•Image loss: 0 ∼ 4mm
•Void amount: 1 ∼ 3mm
Void area 0~3mm
Scale image
Paper end
10 20 30 40 50
|
|
|
|
|
|
|
|
| Solid edge |
| |
|
|
|
|
| Image loss | ||
| 0~4mm | ||
|
|
(12) Press the clear key and cancel simulation
Note: When the
When adjustment is made with simulation
<Note> The keys and display functions are the same as simulation
[Adjustment procedure]
(1)Put a scale on the original table.
(2)C → P → 0/◊ → P → 5 →
0/◊ → PSW → 2 → PSW
With the above key operation,
(3)The lower two digits of L1 value is displayed on the copy quantity display. The top digit is for data identification.
•L1 : Lead edge shift at 200% (mm, 3 digits)
•L2 : Lead edge shift at 100% (✕✕✕mm, 3 digits)
Example of display
•For 42.5mm, the display is 2 5 .
(4)Use the % key and the 10 digit key pad to set A and b values to zero. Make copies at 100% and 200%.
•0/◊ → 0/◊ → 0/◊ → % key → 0/◊
→ 0/◊ → 0/◊ → PSW (A copy at 100% is made.)
• Enlargement key → (Lens shift, ready) → PSW (A copy at 200% is made.)
(5)Measure the distance between the copy paper lead edge and the copy image lead edge in each copy. Enter L1 and L2 values with the zoom key and the 10 digit key pad. With this operation,
Input procedure
(Example)
When L1 = 24.5 mm and L2 = 15.0mm:
Check that the lowest digit of the magnification ratio display is "A," and perform the following key operation.
2 → 4 → 5 ("45" is displayed on the copy quantity display.)
→ % key → 1 → 5 → 0 ("50" is displayed.) → PSW
(6)After this, check shift and image loss, and void amount in each copy similarly to simulation
2-4. Original detecting section
A. Original detecting arm unit adjustment
1OC switch ON timing adjustment
Execute simulation
→ PSW)
•Slowly tilt down the original detecting arm unit and loosen the original cover switch actuator adjustment screw so that the
auto paper selection display lamp turns off when the height from the table glass to the arm unit top is 36.5 ±0.5mm. Then
slide the actuator to adjust. (If the original cover ON timing is shifted, the original detecting function may malfunction.)
Original detecting arm unit
36.5 0.5
Glass
Original cover switch actuator
Actuator adjustment
screw
7 – 15