Sharp SF-1120, SF-1020 service manual SEC Secl Seeg SUK SCA, Off

Main code	Sub code					Content
26	06	Destination setting
		Used to set the destination (Japan, SEC, etc.).
		When this simulation is executed, the currently set destination is displayed on the copy quantity display.
		Enter the set value and press the PRINT button to store it.
			Set value	Destination
			0	Japan
			1	SEC
			2	SECL
			3	SEEG
			4	SUK
			5	SCA
			6	EX inch series
			7	EX AB series
			8	EX inch series (FC)
			9	EX AB series (FC)
			10	Taiwan/China
	07	Drum sensitivity setting
		Used to set the drum sensitivity.
		When this simulation is executed, the currently set drum sensitivity is displayed on the copy quantity display.
		Enter the set value and press the PRINT button to store it.
			Set value	Drum sensitivity
			1	1
					← Initial value
			2	2
			3	3
	10	AE original density setting
		Used to set the original density.
		When this simulation is executed, the currently set original density is displayed on the copy quantity display.
		Enter the set value and press the PRINT button to store it.
			Set value	Original density
					← Initial value
			0	Normal
			1	Thin original
		When a dark original is copied in the AE mode, the lead edge (about 4mm) is not copied. If it is necessary to copy
		the lead edge, set this simulation to “1.”
	13	Warm-up mode setting
		Used to set the main motor operation mode during warm-up.
		When this simulation is executed, the currently set warm-up mode is displayed on the copy quantity display.
		Enter the set value and press the PRINT button to store it.
			Set value		Warm-up mode
							← Initial value
			0	Normal mode
			1	The main motor rotates until warm-up is completed.

18Toner save mode setting (Japan/SUK only) Used to set ON/OFF of the toner save mode.

When this simulation is executed, the currently set value is displayed on the copy quantity display. Enter the set value and press the PRINT button to store it.

Set value	Toner save mode
		← Initial value
0	ON
1	OFF

8 – 10