Professional Access Point

Administrator Guide

Figure 1. Ethernet Connections When Using DHCP for Initial Configuration.

Switch

Administrator Computer

Professional Access Point

Figure 2. Ethernet Connections When Using Static IP Address for Initial Configuration.

Administrator Computer

(This computer must have an IP address on the same subnet as the access point.)

Professional Access Point

2.Connect the power adapter to the power port on the back of the access point, and then plug the other end of the power adapter into a power outlet (preferably, via a surge protector).

UK Users

Note

Note Replace the plug on the power adapter with the UK standard plug that is supplied in your USRo- botics package. Apply enough pressure to cause a click and firmly seat the new plug in the

to adapter.

The access point may take up to one minute to boot. To ensure a smooth installation process, USRo- botics recommends that you wait one minute before proceeding with “Step 3. Run the Detection Util- ity to find access points on the network”.

A Note About Setting Up Connections for a Guest Network

The Professional Access Point offers a Guest Interface that allows you to configure an access point for controlled guest access to the network. The same access point can function as a bridge for two different

Setting Up and Launching Your Wireless Network - 25

Page 25
Image 25
USRobotics Instant802 APSDK manual UK Users