Install and configure ITG ISL Trunk node Page 175 of 378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
IFC SL1
ESGF
ISGF
Interface type for D-channel:
Meridian Customer Defined Network (MCDN)
ESIG interface with GF platform (QSIG)
ISIG interface with G F platform (QSIG)
Note 1:
The ESGF and ISGF r esponses are allowed i f
the QSIG and QSIG GF packages are both equipped.
Note 2:
The IFC entry must mat ch the protocol entered
in MAT’s ITG Node Properties, Car d Configuration,
Protocol pull - dow n menu.
ISLM xxx Integrated Service Signaling Link Maximum
CHIDs, where:
x = 1-382
ISLM is the maximum number of ISL trunks
controlled by the D-channel. There is no defaul t
value.
BPS (64000) 64000 is default, and is required for the ITG ISL
Trunk DCHIP.
PARM (RS422 DTE) The RS-422 parameters are established with
switch settings on the MSDL card. This prompt is
used to verify those settings prior to enabling the
card.
RCAP ND2 Remote Capabilities
Network Name Display type 2 signaling. All nodes
must use same RCAP.
...
SIDE (USR) Meridian 1 MSDL acts as User side of ISL.
ITG Trunk DCHIP card acts as the Network side of
ISL.
Table 31
LD 17 - Configure the ISL D-channel for the ITG DCHIP card (Large Systems) (Part2 of 3)
Prompt Response Description