Page 228 of 378 Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
5a. If you are transmitting new software to a node containing cards of
the same density:
Make sure Transmit to selected nodes is selected.
Check Card software checkbox.
Click Browse and locate the software file for the card density of
the selected node.
Click Start Transmit. The software is transmi tted to each card in
turn and burned into the flash ROM on the ITG card. Monitor the
progress of the card software trans mission in the Transmit Control
window. ITG indicates success or failure of card software
transmission by card TN. Scroll to veri fy that transmission was
successful for all card TNs. The cards continue to run the old
software until rebooted.
Click the Close button and go to step 6.
b. If you are transmitting new software to a node containing a mix of
card densities:
Make sure Transmit to selected cards is selected.
Check Card software checkbox.
Click Browse and locate the software file for the card density of
the selected cards (24-port or 8-port).
Click Start Transmit. The software is transmitted to each card in
turn and burned into the flash ROM on the ITG card. Monitor the
progress of the card software trans mission in the Transmit Control
window. ITG indicates success or failure of card software
transmission by card TN. Scroll to veri fy that transmission was
successful for all card TNs. The cards continue to run the old
software until rebooted.
Click Close button.
Repeat steps 3b, 4 and 5b for the other card density.