Install and configure ITG ISL Trunk node Page 215 of 378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
Transmit ITG trunk card configuration data fromMAT to the ITG trunk cards
ITG Trunk nodes and cards are configured in the MAT ITG ISDN IP Trunk
application and then transmitted to the ITG cards. The configuration data is
converted by MA T to text file s. The ITG cards then get the confi guration f iles
from MAT using a File Transf er Protocol (FTP) server on MAT.

Before you can transmit configuration data

Perform the following procedures in any order before transmitting
configuration data:
• Install the ITG Trunk cards in the Meridian 1 IPE modules or cabinets
and cable them to the T-LAN and E-LAN Ethernet hubs, Ethernet
switches, and IP routers.
• Co nfigure the ITG Trunk data in the Meridian 1. Disable the ITG Trunk
cards in LD32.
• Configure the ITG Trunk data on MAT.
• Connect a local RS232 terminal t o the serial maintenance port t o set the
Leader 0 IP address. Under certain conditions, the local terminal is
required to configure IP routing table entries in the Leader 1 card and
each of the Follower cards.
• Co nnec t the MAT PC to the local E-LAN subnet or to a remote subnet
across the LAN/WAN from a remote subnet.