Install and configure ITG ISL Trunk node Page 213 of 378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
7Repeat steps 7 through 11 until you h ave added all the ESN tra nslation
Dial Plan digits for this destination node.
8Click OK.
The Dialing Plan window is displayed with the added dialing plan
entries.
9Repeat steps 2 through 13 until you hav e added dial ing plan entries for
all the destination nodes in the drop down list and all destinat ion nodes
Not Defined on this MAT PC.
Retrieve the ITG Trun k node dialing plan using MAT

If you are adding a new node to a large existing network, it is more efficient

to retrieve the ITG Trunk node dialing plan from an existing node. Make the

necessary modifications before transmitting th e diali ng plan to the new node.

1In the IP Telephony Gateway - ISDN IP Trunk Main Wind ow, select a n
existing ITG Trunk node which has a dial ing plan similar to one you ar e
creating for the new ITG Trunk node.
2Make sure that MAT can monitor the card state of Leader 0 in the
existing node from which you are retriev ing the dialing plan. Rec ord t he
Management IP address of Leader 0 on the existing node.
3Select the new node and double-click to open its Node Properties
sheet.
4Click the Configuration tab. Record the Management IP address of
Leader 0 on the new node.
5On the Configuration tab, change the Management IP address of
Leader 0 on the new node. Enter the Management IP address of the
Leader 0 card on the existing node which you recorded in Step 2.
6Click Change and then click OK.
7Select the new node in the upper part of the IP Telephony Gateway -
ISDN IP Trunk window.
8Select menu Configuration | Synchronize | Retrieve to open the I TG
Retrieve Options window.