Page 308 of 378 Maintenance
553-3001-202 Standard 1.00 April 2000
Note: All ITG shell commands ar e case-sensitive.Commands are grouped into eight categories, as shown in Tables50-55.
Table 50
General purpose commands (Part1 of 3)
Command Description
cardReset Perform a warm reboot of the ITG card. The card has to be in
the OOS state to be able to use this command.
itgCardShow Show card information.
ldrResTableShow Show Backup Leader and Followers for a given Leader.
itgChanStateShow Show state of channels (for example, busy or idle).
h323SessionShow Show H323 session information for each channel.
itgMemShow Show memory usage.
ifShow Show detailed network interface information, including MAC
and IP addresses.
IPInfoShow This command will return the following IP information:
• IP addresses (for both management and voice networks)
• default router (for both management and voice networks)
• subnet masks (for both management and voice networks)
• SNMP manager
cardStateShow card state (that is Unequipped, Dis abled, Enabled).
serialNumShow Print out card serial number and PEC.
This command displays the same ITG c ard seri al n umber tha t is
displayed from the Meridian 1 IDC command, and the Product
Engineerin g C o de (PEC).
firmwareVersionShow Print out firmware version number.
numChannelsShow Print out number of available channels.
numNodesInFallbackShow List the IP addresses of the nodes that are in fallback to the
conventional voice circuit-switched network.