Maintenance Page 309 of 378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
swVersionShow Print out software versi on.
resetOm Reset the Operational Measurement fi le timer.
logFileOn Turn on logging.
logFileOff Turn off logging.
logFileShow Show if logging is on or off.
logStatus Show if logging is on or off.
displayClear Clear the maintenance display on the faceplate of the ITG card.
shellPasswordSet Change the default ITG shell password.
emodelSim Allow user to interactively determine QoS score.
itgHelp Show the complete command list. “?” also shows the list.
itgCallTrace Shows call trace log.
tLanSpeedSet Set the Speed of the T-LAN.
tLANDuplexSet Set the duplex mode of the T-LAN.
logout Exit the shell.
ping Test remote host is reachable:
ping<host><numPackets><option>
This command sends an ICMP ECHO_REQUEST packets to a
network hosts. The host matching the de stinati on address in the
packets will respond to the request. If a response is not
returned, the sender will time out. This command is useful to
determine if other hosts or ITG cards are properly
communicating with the sender card. The <numPackets>
parameter specifies how many packet s to send; if it is not
included, pings runs until it is stopped by Ctrl-C (which also
exists the ITG shell).
Example: ITG> ping "47.82.33.123", 10
trap_gen SNMP test alarm (one of each type) generation.
Table 50
General purpose commands (Part2 of 3)
Command Description