Page 182 of 378 Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
Configure ITG ISL trunk cards and units

Record the first CHID for each ITG ISL Trunk card on the installation

summary sheet.

NEDC ETH Near end disconnect control from either originating
or terminating side.
FEDC ETH Far end disconnect control from either originating
or terminating side.
...
Table 35
LD 14 - Configure ITG ISL 8- or 24-port trunk cards and units (Part1 of 3)
Prompt Response Description
REQ NEW XX Add new data, where:
xx = 1-8 for NTCW80 8-port ITG Trunk card
xx = 1-24 for NT0961AA 24-port ITG Trunk card
When using REQ = NEW XX, configure only one
ITG Trunk card at a time.
When using REQ = NEW XX, CHID is
incremented for each of the new units created.
You may need to configure partial ITG Trunk cards
due to WAN traffic capacity limitati ons, or Leader
and DCHIP card real-time capacity for very large
nodes and networks.
TYPE TIE Trunk Type.
TIE is the only supported trunk type for ITG ISL
Trunks.
Table 34
LD 16 - Configure the ITG ISL TIE Trunk route data block (Part4 of 4)
Prompt Response Description