Page 276 of 378 OA&M using the ITG shell CLI and overlays
553-3001-202 Standard 1.00 April 2000
• “IP configuration commands” on page288.
• “Download the ITG error log” on page289.
Access the ITG shell through a maintenance port or Telnet
You can access the ITG shell administration and maintenance commands in
two ways:
You can log in through a direct cable connection between the ITG faceplate
maintenance port and the MAT PC.
You can access th e ITG shell from the M AT PC. Refer to “T elnet to an ITG
card through the MAT PC” on page277 for details.

Connect a PC to card maintenance port

1To access the ITG shell, connect a PC to the RS232 serial
maintenance port through DIN-8 connector on the facepl ate of the IT G
Leader 0 card through an NTAG81CA PC Maintenance cable. If
required, use an NTAG81BA Maintenance Extender cable to provide
an extension between the NTAG81CA PC Maintenanc e ca ble and th e
MAT PC.
Alternatively, connect the NTAG81BA Maintenanc e Ext ender cab le to
the female DB - 9 connector of the NTCW84KA E-LAN, T- LAN, DCH,
and Maintenance Port cable (for DCHIP cards), or the NTMF94EA
E-LAN, T-LAN, Maintenance Port cable (for non-DCHIP cards, to
create a more permanent connection to the ITG Trunk card serial
maintenance port.
Note:
Never connect two terminals to the front and back serial
maintenance port connectors at the same time.
2Use the following communication parameters for the TTY terminal
emulation on the PC: 9600 baud, 8 bits, no parity bit, one stop bit.
3When prompted to login, enter current username and password.
Default is:
VxWorks login: itgadmin
Password: itgadmin
ITG>