Page 218 of 378 Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
6Press the reset button on the faceplate to reboot the Leader 0 ITG
Trunk card.
After the reboot is completed, the Leader 0 card will be in a state of
“backup leader”. The faceplate display wi ll sho w “BLDR.” I t canno t ye t
be in a state of “active leader”, until you have success full y transmi tted
the node properties from MAT to the Leader 0 card.
Transmit the node properties, card properties anddialing plan to Leader 0
Verify that the ITG Trunk cards are disabled in LD32 in the Meridian1
before transmitting card properties.
Note: It is necessary to disable ITG Tru nk cards whenever transmitting
card properties or new software.
Use the MAT Maintenance Windows, the MAT System Passthru terminal , or
use a Meridian 1 system management terminal directly connected to a T TY
port on the Meridian 1. Use the overlay 32 DISI com mand to di sabl e the I TG
cards when idle. In the MAT IP Telephony Gateway - ISDN IP Trunk main
window, select View | Refresh and verify that the card status is showing
“Disabled”. If the card status is showing “uneq uipped, ” confi gure the card in
LD14.
1From the MAT Navigator window, double-click the ITG ISDN IP
Trunks icon from the Services folder. The IP Telephony Gateway -
ISDN IP Trunk Main window opens.
2Select the ITG Trunk node for which you want to transmit properties
from the list in the upper part of the window.
3Select Leader 0 from the list in the lower part of the window
4In the IP Telephony Gateway - ISDN IP Trunk Main window, select
menu Configuration | Synchronize | Transmit.
5Leave the radio button default setting of Transmit to selec ted nodes.
Check the Node Properties, Card Properties and Dialing Plan
check boxes.