Page 204 of 378 Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
Configure SNMP Traps/Routing and IPs tab
In this procedure, you define u p to ei ght SNMP T rap d esti natio n I P a ddre sses
and subnet masks, and up to eight Card Routing Tab le Entry IP addre sses and
subnet masks. These SNMP trap and Card routing table settings become
active when you transmit the card properties to the ITG trunk cards .
1Click SNMP Traps/Routing and IPs t ab (see Figure 33).
2Check the Enable SNMP traps check box to enable sending of SNMP
traps to the SNMP managers that appear in the list. You mus t enter at
least one SNMP trap address if you check this opti on. The SNMP trap
addresses determine where event and alarm messages are sent.
Refer to “Configure MAT Alarm Management to receive SNMP traps
from ITG ISL Trunk cards” on page231 to configure MAT Alarm
Notification to mo nitor SNMP traps for ITG cards.
Figure 33
ITG Node Properties window – SNMP Trap Addresses/Routing table IPs tab