Page 178 of 378 Install and configure ITG ISL Trunk node
553-3001-202 Standard 1.00 April 2000
Configure ISDN feature in customer data blockConfigure ITG ISL TIE trunk routes
Table 33
LD 15 - Configure ISDN feature in customer data block
Prompt Response Description
REQ CHG Change customer data block.
TYPE NET_DA TA Gate-opener for networking features.
CUST xx Customer number associated with this customer
data block.
OPT a....a Options.
AC2 aaa bbb ccc ESN call types under AC2 for the INAC feature.
For example, NPA NXX INTL SPN LOC. INAC
stands for automatic insertion of the ESN access
code on incoming calls.
Note:
By default, the INAC feature puts a ll ESN call
types except for CDP under AC1. You enable or disable
INAC per trunk route in LD16 in the IDSN sect ion of the
route data block.
ISDN YES (NO) You must enter YES to configure ITG ISL routes.
- PNI (0) - 32700 Private Network Identifier. You must configure the
PNI to 1 or other non-zero value to support
Meridian Customer Defined Network (MCDN)
features that use non-call-associated signaling.
For example, Network Ring Again (NRAG)
Network Message Services (NMS), Network ACD
(NACD). Each feature needs ISDN signal ing to be
sent across the Meridian 1 network in the absence
of a call.
Note:
The PNI in the custom er data block must be the
same as the PNI config ur e d in t h e rou t e d ata b l ock at the
far end for outgoing calls f rom the far-end toward thi s
Meridian 1 node.
... ... ...