OA&M using the ITG shell CLI and overlays Page 289 of 378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation

Download the ITG error log

The ITG error log contains error conditions and normal events. Some of the
error conditions can be severe enoug h to raise an alarm through SNMP traps.
The following commands can download an ITG error log:
• currLogFilePut
• prevLogFilePut
Meridian 1 system commands - LD 32
You can perform the following Meridi an 1 sy stem a dmini stratio n c ommands :
• “Disable the indicated ITG card” on page 291.
Note 1: The ITG card must be disabled before card properties can be
transmitted from the MAT ITG application to the card.
Note 2: The card reset button is only available in the MAT ITG
application when the card is disabled.
Note 3: Disabling the ITG card in overlay 32 does not disable the acti ve
leader or backup leader functions.
• “Disable the indicated ITG card when idle” on page291.
Note: This will temporarily preven t the ITG node from seizing the por t
from incoming calls.
• “Disable an indicated ITG po r t ” on page 291 .
• “Enable an indicated ITG car d” on page 292 .
• “Ena ble an indicated ITG port” on page292.
• “Display ITG card ID information” on page292.
Note 1: This command displays the PEC (Product Engineering Code)
for the card. The ITG PEC is NT0961AA.
Note 2: The ITG card information displays the same ITG card serial
number that is displayed from the ITG shell using the serialNumShow.
• “Display ITG card status” on page292.