Delta Electronics none manual Status Display Save Setting Display, Abort Setting Display

Chapter 4 Display and OperationASDA-AB Series

4.3Status Display

4.3.1 Save Setting Display

After the SET key is pressed, LCD display will show the following display messages for approx. one second according to different status.

Display Message Description

The setting value is saved correctly.

This parameter is read only. Write-protected. (cannot be changed)

Invalid password or no password was input.

The setting value is error or invalid.

The servo system is running and it is unable to accept this setting value to be changed.

This parameter will not be stored in EEPROM.

This parameter is valid after restarting the drive.

4.3.2 Abort Setting Display

Display Message	Description
	In parameter mode, pressing MODE key can abort parameter
	setting change and return to monitor mode. In parameter setting
	mode, pressing MODE key can return back to parameter mode.
	After returning back to parameter mode, pressing MODE key
	again can abort parameter setting change.

4.3.3 Fault Message Display

Display Message	Description
	When the AC servo drive has a fault, LCD display will display
	“ALEnn”. “ALE” indicates the alarm and “nn” indicates the drive
	fault code. The display range of alarm code “nn” is 1 to 23. For the
	list of drive fault code, please refer to parameter P0-01 or refer to
	Chapter 10 (Troubleshooting).

4.3.4 Polarity Setting Display

Display Message	Description
	Positive value display. When entering into parameter setting
	mode, pressing UP or DOWN arrow key can increase or decrease
	the display value. SHIFT key is used to change the selected digit
	(The selected digit will blink).

Revision March 2008, Doc. Name: 2007PDD23000011 4-3