Delta Electronics none manual Monitor Setting Display

Chapter 4 Display and OperationASDA-AB Series

Display Message	Description
	Negative value display. When the parameter setting is greater
	than four digits (for the setting value within the range of less than
	five decimal places), after the display value is set, continuously
	press SHIFT key for many times and then the lit decimal points
	are used to indicate a negative value.
	Negative value display. When the parameter setting is less than
	five digits (for the setting value within the range of five decimal
	places), after the display value is set, continuously press SHIFT
	key for many times and then the negative sign will show up to
	indicate a negative value.

4.3.5 Monitor Setting Display

When the AC servo drive is applied to power, the LCD display will show the monitor function codes for approximately one second and then enter into the monitor mode. In monitor mode, in order to change the monitor status, the users can press UP or DOWN arrow key or change parameter P0-02 directly to specify the monitor status. When the power is applied, the monitor status depends on the setting value of P0-02. For example, if the setting value of P0-02 is 2 when the power is applied, the monitor function will be Pulse counts of pulse command, the C.P monitor codes will first display and then the pulse number will display after.

P0-02	Display Message	Description	Unit
Setting
0		Motor feedback pulse number (absolute	pulse
		value)
1		Motor feedback rotation number	rev
		(absolute value)

2

Pulse counts of pulse command

pulse

3

Rotation number of pulse command

rev

4

Position error counts

pulse

5

Input frequency of pulse command

r/min

6

Motor speed

r/min

7

Speed input command

Volt

8

Speed input command

r/min

4-4 Revision March 2008, Doc. Name: 2007PDD23000011