Chapter 5 Trial Run and Tuning ProcedureASDA-AB Series

21.The ratio of Load Inertia to Servo Motor Inertia (J_load /J_motor) cannot be shown in the display of JOG parameter P4-05 operation. Please press MODE key twice continuously and the users can see the ratio of Load Inertia to Servo Motor Inertia (J_load /J_motor). Then, execute JOG operation again, press MODE key once and press SET key twice to view the display on the keypad. Check if the value of J_load /J_motor is adjusted to a fixed value and displayed on the keypad after acceleration and deceleration repeatedly.

5.6.1Tuning Flowchart

Revision March 2008, Doc. Name: 2007PDD23000011

5-15

Page 92
Image 92
Delta Electronics none manual Tuning Flowchart