4.7 Using the Network Settings Menus

HINT

zIf connection to LDAP server is not possible, try the following steps:

1.Disconnect the LAN cable, and press the [Shutdown] button on the touch panel to turn the scanner off.

2.Reboot the scanner with the LAN cable disconnected, and enter a nonduplicate IP address.

3.Re-connect the LAN cable to the scanner.

zIf the DHCP server cannot be reached when DHCP is set to [On], the IP Address is set to "169.254.XXX.YYY" (where XXX and YYY are arbitrary values between 0 and 255).

■Setting the Link Speed/Duplex Mode

If the network is not communicating properly, even though the network operating status is correct, change the Link Speed/Duplex Mode settings.

1.

Select the [Network Settings] tab on the top menu.

 

2.

Press the [Network Status] tab on the left side menu.

4

 

The "Network Status" screen shows the status of the currently operating network connec-

 

tion.

 

3.Press the Link Speed/Duplex Mode [List] button.

The Link Speed/Duplex Mode list appears.

4.Change the setting from "Auto-Negotiation" to a fixed Link Speed/Duplex Mode.

5.Press the [OK] button.

The Link Speed/Duplex Mode setting is changed.

fi-6010N Network Scanner Operator's Guide

 

153