If [Both] is selected in "6.9.17 Multifeed Detection (Layer and Length)" (page 399), mulifeeds are |
| |
A | ||
detected by both layer and length. | ||
In this case, set sheets of the same thickness and length in the ADF at any one time. | ||
z Document thickness: 0.065 to 0.15mm | ||
z Document length deviation: 1% or less |
| |
| ||
z Punched holes are not allowed within 17.5mm (0.7in) either side of the center of paper. |
| |
z Do not glue on any other paper within 17.5mm (0.7in) either side of the center of paper. |
|
ATTENTION
zMultifeed detection by layer will often
zMultifeed may not be detected for the top and bottom 25mm of a document.
Area where multifeed detection is possible
17.5mm 17.5mm
Page top
Front side
Feed direction
Page bottom
Center of paper
485 |