Fujitsu MB86617A INT7, INT8, INT9, INT10, INT11, INT12, INT13, INT14, INT15, INT16, INT17, INT18

LSI Specification				MB86617A
	Interrupt	Interrupt Item	Description
	INT7	Isochronous cycle too long	Isochronous cycle exceeded specified time.
			>Informs only if this node is Cycle master.
	INT8	Bus occupancy violation	Node occupied longer time than MAX_DATA_TIME.
			>Need to issue “Bus reset”.
	INT9	Asynchronous packet received	Received Asynchronous packet addressed to	self-node normally, and
			stored data at ASYNC receive specific buffer.
	INT10	CPIF output header is no 47h (Transmit)	Header byte of source packet output from CPIF at transmitting
			MPSG2 -TS is not ‘47h’.
			>Valid only when transmitting MPSG2-TS.
	INT11	Data length short error	Receive packet data length is shorter than data-length of packet header.
	INT12	Data length long error	Receive packet data length is longer than data-length of packet header.
			>Store only data indicated by data-length value to buffer.
			Detected format error in packet received.
	INT13	Packet format error	Occurred convention failure of packet format like Reserved range is not
			‘0’.
			>Delete packet received.
	INT14	Header CRC error	Detected CRC error in the header of packet received.
			>Delete packet received.
	INT15	Data CRC error	Detected CRC error in the data range of packet received.
			>Do not delete packet received.
	INT16	Asynchronous receive FIFO full	ASYNC receive specific buffer is full.
			>Delete following packet received.
	INT17	Asynchronous packet send	Completed sending Asynchronous packet by issueing instruction.
	INT18	Input CGMS or TSCH changed	CGMS or TSCH information input from TSP IC I/F was not consistent
			with the souce packet input just before.
	INT19	Acknowledge missing	Not returned Acknowledge packet in correspondance with Asynchronous
			packet of non -broadcast sent from self-node within specified limit.
	INT20	Acknowledge send	Completed sending Acknowledge packet.
	INT21	Receive EMI or ODD/EVEN changed	Changede EMI data or ODD/EVEN value	of received Isochronous
			packet.
	INT22	First packet received	Received the first packet after setting receive ISO channel.

Rev.1.0 110 Fujitsu VLSI