▼Select accounting
1Open the ‘Scanner’ card in the ‘Original’ section.
2Select ‘Account id’ or ‘User id’ with the section key.
3Set the needed ‘Account id’ or ‘User id’ with the ‘Arrow’ keys.
Using the manual feed for copy jobs
If you want to copy a job on a media type or size that is not available on one of the media rolls, it can be convenient to manually feed cut sheets instead of switching media rolls. The manual feed is a special slot just above the roll drawers on the print engine. You can insert
Note: Only use media as specified in ‘List of available material types and sizes’ on page 253.
▼Copying on
1Press the Manual feed key on the Scanner.
2Select any required other settings.
3Enter the number of copies using the numeric keys.
4Feed the original. The printer display looks as follows:
[21] The printer operator panel with manual feed message
5Press the start key.
6Take your sheet of copy material to the side of the printer engine that contains the Manual feed.
7Use both hands to align the copy material in accordance with the format indication and the sticker on the manual feed table.
8Move the copy material forward in the nip of the roller. This must cause an ample paper bulge over the full width of the page.
9Hold the paper with both hands until the engine pulls in the first part of the sheet.
The bulge will be reduced or it will disappear. A few seconds later the complete sheet will be pulled in the printer.
62 | Océ TDS800 User Manual |
