3Push the waste box forward and push it to the right hand side to close the waste box (see Figure 120).
[120] Close the waste box
Clean the reinforcement knives
The knives of the reinforcement unit get sticky from the glue on the reinforcement tape. Clean the knives when you insert a new tape roll (see ‘Change the tape roll in the reinforcement unit’ on page 196) or when an error in the Reinforcement Unit occurred.
Put the knives into a position so that you have access to all parts.
Attention: To avoid damage to the Reinforcement Unit, only use the original Cleaner K and Fixing Unit Cleaning Oil (silicon oil) from Océ.
▼How to clean the reinforcement knives
1Press the
2Press the left selection key to shift the focus to ‘Clean reinf. knife’. A shadow effect is used to indicate that the focus is set to this menu.
3Select the right selection key ‘Clean’. The reinforcement knives are placed in the correct position.
4The machine stops and the yellow indicator on the printer goes ON.
5A picture of the printer appears on the display with the side door of the reinforcement unit flashes.
6To see the text, press the ‘text’ key.
Note: When a job is running, the message ‘Job interrupted’ appears. The machine stops running after it has correctly finished the prints that were already in the printer.
7Open the side door of the reinforcement unit (E).
Maintenance | 209 |
